Equipment Connections - Eaton Evolution 650 Pulsar Serie Manual De Instalacion Y Uso

2.6

Equipment Connections

Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source and
the true electrical consumption of the total load.
1. Connect the input power cord to the AC outlet receptacle.
2. Connect the loads to the UPS outlets as shown. It is preferable to connect the priority loads to the two outlets
marked (3) and the nonpriority loads to the two programmable outlets marked (5).
To program shutdown of outlets (5) during operation on battery power and thus optimize the available backup time,
the EATON communication software is required.
Evolution 650/850/1150
3
5
Evolution 650/850/1150 Rack
a
Evolution 1550 Rack
Pb
AC INPUT
Site wiring fault
AC OUTPUT
36Vdc, 9Ah
Pb
R
55K6
or U.P.S.
AC Input Volt 120V~1O RS232 RPO ROO
Amps 12A MAX SITE WIRING
Hertz 50/60 Hz
AC INPUT FAULT
AC Output Volt 100/120/127V~1O
Amps 12.96/12/11.34A
Hertz 50/60 Hz
W/VA 1100W/1440VA
Evolution 1550
3
5
Load
Load
Programmable
1 2
55K6
(E87247)
RS232 or RPO ROO
AC OUTPUT Programmable
I max 12A
1
U.S. PAT. No. 6,094,363
a
2. Installation
AC OUTPUT
I max 12A
2
U.S. PAT. NO. 6,094,363
36Vdc, 9Ah
Pb
R
1
55K6
U.P.S.
AC INPUT
Load
2
86-81700-00EN A02 - Page 15
Load