Unold 87635 Manual De Instrucciones página 22

Copyright UNOLD AG | www.unold.de
Danger of burns!
DE
1.
EN
2.
FR
3.
NL
IT
ES
4.
PL
5.
6.
7.
8.
9.
10. Now work your way down slowly and evenly
11. Please remember that the straightener plates
12. Always switch the appliance off using the EIN/
13. TIP: You can also curl your hair with the
22 von 60
Open the appliance by pressing the button for
the safety locking mechanism.
Prepare your hair as described in the chapter
„Before first use".
Attention: your hair should be completely dry
before straightening. Straightening your hair
when it is still damp will damage your hair.
Therefore you should dry your hair well using a
hair dryer, if necessary.
Connect the plug to a wall socket (220–
240 V~, 50 Hz)
Separate the combed hair into strands no more
than 5 cm wide. If necessary, separate the
strands using hair clips.
Switch the appliance on pushing the button
EIN/AUS [ON/OFF]. The indicator light lights
up red.
Heat the appliance up for approx. 90 seconds
in order to achieve the best styling result.
Open the appliance and place a small section
of hair between the straightening plates close
to the root.
Shut the appliance.
to the ends of your hair. Maintain the appli-
ance firmly closed during this process. Never
work the same part for more than two sec-
onds to avoid damaging your hair. For an even
and straight look, work your way straight down
keeping the appliance close to your head.
Working your way through slightly lifting the
appliance will give your hair more volume.
are very hot after use.
AUS [ON/OFF] switch before disconnecting
the plug from the wall socket. To protect the
smoothing plates from being opened uninten-
tionally, press the button for the safety locking
mechanism again.
straightener! Place the strand between the
Stand 12.3.2020