Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Avoid storing battery cartridge
(2)
in a container with other metal
objects such as nails, coins, etc.
Do not expose battery cartridge
(3)
to water or rain.
A battery short can cause a large
current flow, overheating, possible
burns and even a breakdown.
Do not store the tool and battery
6.
cartridge in locations where the
temperature may reach or exceed 50
°C (122 °F).
Do not incinerate the battery car-
7.
tridge even if it is severely damaged
or is completely worn out. The bat-
tery cartridge can explode in a fire.
Be careful not to drop or strike battery.
8.
Do not use a damaged battery.
9.
The contained lithium-ion batteries
10.
are subject to the Dangerous Goods
Legislation requirements.
For commercial transports e.g. by third
parties, forwarding agents, special
requirement on packaging and labeling
must be observed.
For preparation of the item being
shipped, consulting an expert for haz-
ardous material is required. Please
also observe possibly more detailed
national regulations.
Tape or mask off open contacts and
pack up the battery in such a man-
ner that it cannot move around in the
packaging.
Follow your local regulations relat-
11.
ing to disposal of battery.
SAVE THESE
INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will also
void the Makita warranty for the Makita tool and charger.
Tips for maintaining maximum
battery life
1.
Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2.
Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
Charge the battery cartridge with room tempera-
3.
ture at 10 °C - 40 °C (50 °F - 104 °F). Let a hot
battery cartridge cool down before charging it.
4.
Charge the battery cartridge if you do not use
it for a long period (more than six months).
Symbols
The followings show the symbols used for tool.
volts
direct current
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
1
► 1. Red indicator 2. Button 3. Battery cartridge
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
4 ENGLISH
3
2
Publicidad
Tabla de contenido
