End Of Programming - Crouzet CTR24L-2514 Instrucciones De Puesta En Servicio

4.6 RESET mode (totaliser 1)
4.7 Multiplying factor (totaliser 2)
4.8 Dividing factor (totaliser 2)
4.9 Decimal point (totaliser 2)
manual reset via the red
RESET key and
electrical reset via the
RESET input
no reset (red RESET key
and RESET input locked)
only electrical reset via
the RESET input
only manual reset via the
red RESET key
It can be set from 00.0001
up to 99.9999.
The decimal point is set to
4 decimal places.
„0" is not accepted!
It can be set from 00.0001
up to 99.9999.
The decimal point is set to
4 decimal places.
„0" is not accepted!
The decimal point defines
the way of displaying the
count values. It does not
affect counting.
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000 three decimal places
5.0 RESET Mode (totaliser 2)

5.1 End of programming

manual reset via the red
RESET key and
electrical reset via the
RESET input
no reset (red RESET key
and RESET input locked)
only electrical reset via
the RESET input
only manual reset via the
red RESET key
The programming routine
is repeated once more.
The values set until now
can be checked and modi-
fied.
The programming routine
wil be left and all values
set will be stored as new
parameters.
Afterwards the device is
ready for operation.
3