Polygroup SUMMER WAVES QUICK SET Serie Manual Del Usuario página 10

Setup Instructions Continued
3. Inflate the top ring. Squeeze the base of the valve stem to open an internal check valve while inflating.
AFTER ABOUT 1-INCH OF WATER IS ON THE BOTTOM, STOP FILLING AND COMPLETELY SMOOTH OUT ALL WRINKLES FROM THE BOTTOM OF THE
POOL, WORKING FROM THE CENTER OUTWARD. BE SURE THE FLOOR OF THE POOL IS COMPLETELY ROUND AND FLAT.
NOT FOLLOWING THIS STEP WILL MAKE THE POOL FILL UNEVENLY AND THE POOL MAY START TO LOOK LIKE AN OVAL OR LOOK MISSHAPEN.
SEE FIGURE 2-3 YOU MAY NEED TO START OVER.
4. Next pull all the outer walls up straight making sure they are not under the pool floor, also make sure to pull up the top ring, all around the pool, so that it fills
evenly.
NOTE: IF MORE THAN 1-2 INCHES OF WATER COLLECTS ON ANY ONE SIDE BEFORE THE POOL STARTS FILLING IN THE CENTER, THE POOL IS NOT
LEVEL ENOUGH, AND MUST BE CORRECTED. SEE "SITE PREPARATION," ABOVE.
ADDITIONAL NOTE: THE WEIGHT OF THE WATER WILL PREVENT ADJUSTMENT AFTER THIS POINT.
5. Now, as you continue filling, the inflated ring will rise as the water deepens. The Maximum Water Level FILL LINE is printed on the inside of the pool liner.
Once this is done, if your pool included a filter/pump system please refer back to the "Swimming Pool Filter System" owner's manual and follow all instructions for
the Installation of the filter pump.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
10
SETUP INSTRUCTIONS
1
MST. Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
2
2-3
4