Black+Decker TURBO PRO VCBD2040 Instrucciones página 11

5. To remove extension tubes, just pull out the ends of each tube.
HOW TO USE
This appliance is intended for household use. It is for indoor use only.
Important: The power cord has a yellow marking and a red marking to help you determine the maximum
length to use. Up to the yellow marking is the recommended length. Never pull cord beyond the red marking.
6. Holding the power cord by the plug, pull out the required length and plug into a standard electric outlet.
7. Press the On/Off push button
8. Adjust the suction power by sliding the vacuum suction control on the hose.
9. Press the foot pedal on the sweeper to switch to floors or carpets.
10. As you vacuum, check the removable plastic dust collector frequently; when the dust collector is full
empty it. To empty the dust collector, see Dust Collect or in the Care and Cleaning section.
11. When finished vacuuming, press the On/Off push-button
12. Unplug unit.
13. Press the retractable cord push button
Caution:
• The cord moves fast when retracting. Stand clear of the cord as it rewinds so it does not swing into you.
• To prevent cord from whipping when rewinding, hold plug when rewinding onto cord reel.
USING CLEANING TOOLS
The cleaning tools can be attached to either the end of the extension tube or the flexible hose.
VACUUM ACCESORIES
2 EXTENSION TUBES: use in combination with flexible hose for added length and height.
FLEXIBLE SWIVEL HOSE: flexible hose with an adjustable suction feature.
COMBINATION FLOOR BRUSH: use to vacuum grime on all surfaces.
CARE AND CLEANING
This appliance contains no user-serviceable parts. Refer service to qualified service personnel.
Important: Always turn off and unplug the unit before cleaning any parts.
CLEANING
Note: To maintain maximum cleaning performance, empty the dust collector when is at max level, and clean
or replace the HEPA exhaust filter, intake filter, the cyclonic HEPA filter and the motor dust filter often.
DUST COLLECTOR
To remove dust collector, press release button on the handle and lift up.
14. Press and release button on the dust collector to open the lid and empty the dust collector.
15. Wash in warm sudsy water with mild detergent.
16. Also clean and wash the motor dust filter and dry thoroughly before reinstalling.
17. Dry the dust collector completely with a soft cloth before reinstalling.
CYCLONIC HEPA FILTER
to start the vacuum cleaner.
. The cord winds back into the unit.
11
to turn off the unit.