Operation - Glacier bay VWD2266W-1 Guía De Uso Y Cuidado

Operation

1
Dispensing cold water
iMPOrTanT: Drain approximately 4 glasses of water from each tap before initial use. This does not need to be done with replacement
bottles.
□ Place a glass under the spigot.
□ Press the cold water dispensing button (E) until the desired amount
of water is dispensed.
□ When the blue LED light (L) illuminates, the cold water has reached
optimum temperature (compressor is off).
□ When the blue LED light (L) is off, the cooling cycle is active (compressor
is on).
2
Dispensing hot water
WarninG: The hot water is heated to approximately 194˚F / 90˚C. Temperatures above 125˚F / 52˚C can cause severe burns from scalding.
DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING BUTTON WITHOUT PROPER AND DIRECT SUPERVISION.
To prevent hot water from being dispensed accidentally and possibly harming
a child, the hot water dispensing button can only be operated when the child
resistant safety feature is activated.
□ Place a glass under the spigot.
□ While holding down the red child safety lock (C), press the hot water
button (D) until the desired amount of water is dispensed.
□ Release the hot water dispensing button, and the child safety lock (C)
will re-engage (locks) automatically.
□ When the red LED light (L) illuminates, the hot water has reached
optimum temperature (heater is off).
□ When the red LED light (L) is off, the hot water heating cycle is active
(heater is on).
L
C
C
8
E
D