Important Safety Instructions; Installing And Connecting - Airfree Fit 800 Importantes Instrucciones De Seguridad

IMPORTANT SAFETY INSTRUCTIONS

When installing and using this electrical equipment, basic safety precautions should always be
followed, including the following:
READ AND FOLLOW ALL INSTRUCTIONS.
Airfree ® is not intended for use by persons with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge. Children should be supervised to
ensure that they do not play with the appliance.
Do not place your Airfree
electric and harmful shock hazard and damage to the unit itself.
Do not obstruct Airfree
will increase heating inside the ceramic core causing the device to shut off. If such
condition persists a general cut-off system will cut power supply requiring replacement
of the circuit board by an authorised dealer. This incident is not covered by the
Airfree ® warranty.
Do not attempt to open Airfree
objects as it may cause electric shock. Any attempt to open or tamper Airfree
void the warranty.
To clean Airfree
surface. Do not attempt to open Airfree
Always keep Airfree
will be shut off until it goes back to the vertical position.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons or any authorised warranty service shop to avoid
potential hazard events. When returning your Airfree
well protected preferably inside its original box, to avoid additional damages.
Airfree shall not be placed near flammable and toxic products.
®
SAVE THESE INSTRUCTIONS
For wall mount devices, drill holes spaced apart as per the attached diagram. Add
the 2 enclosed screws leaving 5 mm free distance between the wall and the top of the
screw, in order to allow the device to slide down and be secured. Make sure Airfree®
can not be easily removed after installation by exercising upward pressure. If loose,
please remove device and gradually tighten the screws until Airfree is really secured
to the wall.
Optionally, you may purchase good quality double side tape or self-adhesive Velcro
tapes to attach your model to the wall. Simply attach 2 parallel vertical tapes (10 cm
each) to each side of the back of the device. Make sure the device is on its upright and
vertical position when pressing it against the wall for attachment
® in direct contact with water or liquids as it can cause an
® air outlets with items such as towels, clothing, curtains, as it
® or touch its internal components. Do not insert any
® , unplug it from the electric outlet and use a dry cloth to wipe off its
® in its vertical position as shown in the picture, otherwise the unit

Installing and Connecting

® to clean it inside which is not necessary.
® for repair please make sure it is
4 4
® will