Mark AMC 10 Manual De Uso página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
CAUTIONS WHEN OPERATING THE AMPLIFIER
1. Do not drop the waistband PA amplifier on the floor or strike the waistband PA amplifier with any
object.
2. Always charge the battery before used and full charge the battery if the waistband PA amplifier is
not be used for a period of time to keep the normal life span of it.
3. This amplifier should be kept away from high-power wireless emitting sources to avoid signal interference.
4. This amplifier is equipped with magnetic speaker, and should be kept away from the computers and
TVs for over 60 cm. when using. Otherwise, the electromagnetic field will affect its usage effects.
5. Please do no litter the used-up battery, and put it to relevant recycle box.
6. Do not modify the product. Otherwise, it may damage the components, short-circuit, or cause electric
shock.
CHARGE THE LITHIUM CELL
1. When the POWER LED turns to orange colour, please charge the built-in Li battery immediately
as below:
- In OFF position, plug one end of the AC/DC adaptor to the charge input jack of the PA amplifier, and
plug the other end of it to the local AC power socket.
- The CHARGE LED is in orange when charging means the unit is normal working. The CHARGE LED
turns to green when it is fully charged.
- Then plug out the AC/DC adaptor from the AC socket. Be sure to use the correct voltage AC/DC
adaptor to avoid damage or accident.
- The charge temperature is 0-45ºC.
2. Normal charge time is approx. 5 hours. Recommend not to charge the Li cell over 24 hours.
3. Normal working time is approx. 5hours with the full charged battery.
4. The built-in Lithium battery can be repeat charged for more than 500 times.
5. If you are not going to use it for 1 or 6 months, please recharge the PA amplifier for around 1.5 hours
to have 40% or 50% capacity of the Battery, then put it in a dry, cool place and in the temperature of
-20º to 45º C and keep the PA amplifier in OFF position.
RMS
Output Power
Power Supply
Frequency Response
Distortion Factor
Audio input
Operating Temperature
Dimensions
Weight
8.5W max, THD < 20% in full battery level
12W max. Load (4
?
Built-in DC 7.4V/1000 mAH Lithium battery
100 Hz - 10 kHz (+/- 3dB)
< 1% (1W)
Stereo 250 mV/1k ?
-20º to 45ºC
125 x 95 x 43 mm
260 g
AMC 10
).
User Manual/Manual de Uso
Pag. 4

Publicidad

Tabla de contenido
loading

Tabla de contenido