Safety Instructions - hjh OFFICE VM-SA Manual De Instrucciones

4
EN
ENGLISH
Introduction
Thank you for purchasing a hjh OFFICE product.
Please read the following instructions carefully.
Illustrations may slightly differ from the actual execution.
For reasons of clarity, not all conceivable assembly variants can be described.
If you need more information and help, please contact us:
Tel .: +44 (0) 203 318 5230
email: service@hjh-office.co.uk
Note
First unpack all parts of the delivery and check them for possible transport damage.
Damaged or missing parts can affect the safety and function. In this case please contact us first before
proceeding with the installation.
In order to ensure an easy construction, we recommend at first to tighten all screws only partially.
Only after all screws have been inserted into their respective thread, should they be tightened.

Safety instructions

Caution: Do not exceed maximum listed weight capacity.
Serious injury or property damage may occur!
Do not place hands on or near support bars. Pinch points are created during lifting and lowering the worksurface.
Failure to follow these instructions may result in serious personal injury.
When carrying the lift table, be sure to hold the bottom with both hands. Do not subject the table to a separate force.
This can cause the tabletop to be out of step with the bottom structure.
The desktop rises. Stepless height adjustment. Hands must not exceed safety shield below the tabletop use, otherwise
it will pinch
Keep monitor and laptop base fully on the worksurface. Allowing any part of base or stand to hang off the edge may
result in property damage and or personal injury.
Raise worksurface slowly. Raising worksurface too fast may create an unstable situation resulting in property damage
and or personal injury.
Leave enough slack in cable to allow for full range of vertical motion (16" / 40.7 cm). Failure to heed this warning may
result in
To avoid the potential to pinch cables it is important to follow the cable routing instructions in this manual.
Failure to follow these instructions may result in equipment damage or personal injury.