First Time Operation; Switching The Clipper On And Off; Adjusting The Blade - VOSS.farming easyCUT pro Instrucciones De Operación

7

FIRST TIME OPERATION

NOTICE
► Before first time operation, make sure that the blades are oiled to prevent
damage or defects to the machine. The blades are already oiled at the factory,
but it is recommended to check this before first use.
► Ensure that the blades are sharp before use to avoid injury to the animal by
pulling hair.
► To slow the dulling of the blades, clean the animal's coat thoroughly before
each clipping.
7.1

SWITCHING THE CLIPPER ON AND OFF

1. Make sure that the on/off switch (3) is in the „O" position.
2. Connect the power cord to a power outlet that meets the requirements of the
clipper.
3. To switch on the clipper, set the on/off switch (3) to „I".
CAUTION
► Only use the machine with correctly inserted and sharp blades.
► Do not use the machine for longer than the specified maximum continuous
operation time. Afterwards, let the machine rest for at least 10 minutes.
4. To switch off the machine, set the on/off switch (3) to „O".
7.2

ADJUSTING THE BLADE

Before use, the tension of the blades should be correctly adjusted. If the tension
between the blades is too low, hairs will collect between them, which will considerably
worsen the clipping.
1. Switch off the clipper and disconnect it from the
power supply.
2. To adjust the shearing blades, tighten the
tensioning nut (2) until the first resistance is felt
(fig. 1).
3. To achieve an optimum tension between the
shearing blades, do not continue to turn more
than 1/4 turn.
Info
► If the clipping performance deteriorates, the tension between the shearing
blades is no longer correct. Switch off the machine, disconnect it from the
power supply and turn the tensioning nut (2) for 1/4 turn to restore the
tension.
► If the result does not improve after adjusting the tension, the shearing blades
must be sharpened. Contact qualified personnel for this.
22
INSTRUCTION MANUAL VOSS.FARMING EASYCUT PRO
Tighten Loosen
Fig. 1
85290 | 11 | 2020 | V2