ENGLISH
PARTS
1. On/Off switch
2. Zoom wheel
3. Length position indicator
4. Charge indicator
5. Trimmer assembly
CHARGING YOUR APPLIANCE
CHARGING
•
It is recommended to fully charge your product before using for the first time.
•
Ensure the product is switched off.
•
The adaptor automatically adjusts to a main voltage between 100V and 240V.
•
Connect the charging adaptor to the product and then to the mains.
•
The indicator light below the power switch will light up to indicate the product is
charging.
•
Charge time for the battery from empty to full charge is 10 hours.
•
Run time from fully charged is up to 40 mins.
•
To preserve the life of your batteries, let them run out completely every 6 months and
then fully charge.
•
Do not recharge your product after each use as this will shorten the life of the battery.
NOTE: this product is rechargeable only and cannot be used in corded mode.
INSTRUCTIONS FOR USE
FITTING THE ADJUSTABLE COMB
•
Hold the trimmer in one hand with your thumb firmly on the zoom wheel to keep it
from turning. Ensure the length position indicator is at 0.4.
•
Slide the comb down the grooves until it clicks into place.
•
The comb can only be attached one way.
ADJUSTING THE TRIM LENGTH
•
The trimmer comb can be adjusted to give you 17 different trim lengths simply
by turning the wheel to the desired setting.
•
Select the comb length by rotating the zoom wheel upwards to increase the
length and downwards to decrease the length. Please see the table below for
the different length increments.
•
The wheel will click into place as it reaches each setting and the setting
number will appear on the length position indicator.
4
6. Adjustable comb
7. Charging connector
Not shown:
•
Pouch