Publicidad
Idiomas disponibles
Idiomas disponibles
WF 0165
DESCRIPTION
1. Front grille.
2. Metallic blade.
3. Rear grille.
4. Motor shaft.
5. Motor.
6. Male motor support.
7. Motor fixing screw.
8. Female motor support.
9. Wall support (can be oriented up or down).
1. As it is a heavy fan, you should place it on a resistant wall. Once located the desired place, put the
wall support on the wall and mark its holes with pencil or marker.
2. Drill to holes, place inside the holes the clamping tubes, put wall support on the wall onto the holes
and screw it.
3. Insert the tube in wall support (orient it upward or downward as you desire) and fix the position
tighten its screw.
4. Place motor in female support and fix it with the screw (7). With this screw you can set the tilt of
motor.
5. Mount rear grille on front of motor and screw it to place it. After that insert the blade in the motor
shaft and adjust it with its screw.
6. By last, put the front grille in front of rear one and adjust it with top hook and fix the grilles with
frame flanges.
OPERATING INSTRUCTIONS
• Step 1: Please make sure the Speed knob is in the 0 position. Plug cord into any standard AC outlet.
• Step 2: The speed is adjusted by moving the knob left or right to the desired setting (0-Off; 1-Low; 2-
Medium; 3-High)
• Step 3: To connect swing function, unscrew the screw on bottom of motor and change of position as
below pictures show.
9
Publicidad
