Using The Device - WMF LINEO Serie Instrucciones De Uso

The program ends automatically, both the Ice crush and Interval buttons now
illuminate again.
You can end the program at any time by pressing the Interval button.
Then thoroughly rinse the whole glass jar (3) with clean water.
Glass jar
The cap (1) in the lid (2) can be removed by turning it clockwise. It can then be
used as a measure (20/40/60 ml).
The glass jar (3) can be dismantled, especially for cleaning. To do so, place the
jar on the table with the opening facing down and rotate the blade assembly (5)
clockwise (see diagram).
Note: In order to ensure the tightness of the glass jug, the blade unit must be
screwed on tightly. The blade unit is easier to tighten if you apply a few drops of
cooking oil on the sealing side of the glass jug (see figure).

Using the device

Clean the glass jar (3), lid (2) and cap (1) before using for the first time. Make sure
that you do not injure yourself on the sharp blade. Place the glass jar (3) on the
drive unit (6).
Add the ingredients, close the glass jar (3) with the lid (2) and cap (1) and set the
selector switch to the desired operating mode.
Speed Use
low Instant drinks, soft fruits and cocktails
(min) with alcohol
low Milkshakes
(min)
medium Soups, milkshakes with harder fruits,
sauces, baby food, vegetables
high Nuts, hard cheese, dry bread
(max)
Additional ingredients may be added while the motor is running. To do this,
simply remove the cap (1).
You can now remove the blade assembly
(5) and the sealing ring (4).
To assemble, begin by attaching the
sealing ring (4) to the blade assembly (5).
When doing so, make sure the sealing ring
(4) is fitted properly on the blade assembly
(5). Then, place the blade assembly (5) into
the glass jar (3) and turn anticlockwise
until tightly fitted.
Maximum time
40-60 s
1 – 2 min
1.5 – 2 min
40-60 s
13