Publicidad
ASSEMBLY
1) Unroll the mat on smooth, soft ground such as grass or sand to prepare for inflation. Rocks and
concrete are abrasive and may cause damage to your Aqua Trainer Mat.
2) Prior to inflation, check the valve of the Aqua Trainer Mat to confirm that it is set in the
CLOSED (One-way) position. This will stop the air from escaping once it has been pumped into
the board. Push and turn the stem at the center of the valve 45 degrees to change the valve from
OPEN to CLOSED. When the stem stays locked inward, the valve is OPEN for easy deflation.
From the OPEN position, push and turn the stem 45 degrees to reach the CLOSED position. The
stem will 'pop' outward once the CLOSED position is reached and the valve will allow air in, but
not out of the board.
3) Insert the pump hose fitting into the valve. Push inward firmly while twisting the fitting clockwise
to lock in place.
4) Once the hose fitting is locked in place, put both feet on the pump base and begin pumping
with smooth even strokes. INFLATE TO 15.0 psi (1,03 bar) for proper stiffness and performance
when being used by an adult. Once the board is properly inflated, seal the valve with the tethered
valve cap by inserting and turning it counter clockwise.
NOTE: Aqua Trainer Mat comes with a high-pressure push pump complete with High-Pressure
fitting for inflation. This pump is designed to inflate the Aqua Trainer Mat properly, and it has the
added benefit of a built-in pressure gauge. TO REMOVE THE HOSE FITTING you may need to
press firmly inward on the fitting while turning it counter clockwise.
WARNING: DO NOT OVER-INFLATE. Over-inflation can cause permanent and/or irreparable
damage to this product. Using an air compressor is the most common cause of over-inflation.
MAXIMUM acceptable pressure under any circumstances is 15.0 psi (1,03 bar).
Publicidad
