LG CRD-8240B Manual De Usuario página 11

Interface
connector
IDE Cable
Figure 9. Connecting the IDE Cable
to the Interface Connector
CONNECTING AN AUDIO CABLE
Pin assignment
The pin assignment of the
audio output connector is
as follows.
GND GND
R-Channel L-Channe
* Pin assignment of the audio cable
GND
L-Channel
Figure 10. Connecting an Audio Cable
to the Audio Output Connector
Pin 1
Red-edge
l
Audio
to Audio
Cable
Equipment
(sound card)
GND
R-Channel
Disc Clips
E-11
Step 6. Connect the 40-pin IDE Cable to
the back of the CD-ROM Drive.
Please make sure that the red
edge of the IDE Cable is
connected to Pin 1 on the CD-
ROM Drive.
If you want to connect audio equipment or
a sound card to the CD-ROM drive, use
an audio cable to connect the drive to the
sound device.
Note: This CD-ROM Drive can be used
vertically.
• To use the drive vertically, open the
drawer and move the 2 plastic clips on
the bottom to hold a disc vertically. After
placing a CD into the tray, move the top 2
plastic clips to hold the top of the CD in
place. Use only standard 12cm discs.
• Do not touch the unlabeled side of the
disc.