Cable Remote Control (X-2); Wireless Remote Control - involight FOG1200 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 47
would destroy the pump. Such a case is not covered by the warranty!
.

4.2 Cable remote control (X-2):

The device can be controlled with the cable remote control. Plug the cable remote control into the 5-pin connector
"Controller X-2" on the back of the device. (See section 4.1 Housing Backs).
1.
2.
1. Status LED:
Using the status LED, you can quickly see if your fog machine is ready for fogging or heating up.
2. Trigger button:
Press the "FOG" button. The machine generates fog until you release the "FOG" button.

4.3 Wireless remote control:

Your "FOG1200" is also equipped with a radio remote control. This makes this fog machine very flexible. A receiver
(W-2) and a transmitter (W-1) are included in the delivery.
Receiver (W-2):
Status-LED:
Using the status LED, you can quickly see if your fog machine is ready for fogging or heating up. Green = Ready,
Red = Heating
If you want to use the radio remote control for your "FOG1200", please pull the antenna completely out to ensure a
secure connection. The remote has a maximum range of 30 - 50m outdoors. So you can use the "FOG1200"
ideally also for theater or presentation purposes.
Plug the radio receiver (W-2) into the 5-pin socket "Controller W-2" on the back of the unit (see section 4.1 housing
parts). Place the receiver so that free reception is guaranteed. Prevent the receiver from being obscured by other
devices. Otherwise, reception errors could occur. The receiver has a magnetic plate, which means that it can also
be found directly on the "FOG1200".
There are four dip switches on the side of the receiver. Set one of the four dip switches to the "ON" position. The
numbered button of the transmitter "W-1", which corresponds to the numbered dip switch, controls the fog output.
Transmitter (W-1):
15

Publicidad

Tabla de contenido
loading

Tabla de contenido