Gira 5448 02 Manual De Instrucciones página 5

Actuador inalámbrico de conmutación de 1 elemento, conector intermedio
Operating mode
Advanced device settings
Parameters
Manual commissioning
Repeater mode
Channel settings
Parameters
32592212 10864992
Switching operation
Push-button operation
Flashing
Continuous on
Continuous off
Basic setting: Switching ope-
ration
Setting options, Basic set­
ting
On, Off
Basic setting: On
On, Off
Basic setting: Off
Setting options, Basic set­
ting
24.03.2017
Switching operation
After switch-on, the device re-
mains stable in the "On" state,
and stable in the "Off" state af-
ter switch-off.
Push-button operation
The device switches "On"
when any channel button of a
radio transmitter is pressed
and "Off" when the button is
released. It is irrelevant whet-
her the "On" or "Off" channel
button is pressed.
Flashing
Switch-on starts flashing and
switch-off stops flashing. The
default flash frequency is 1
Hz. This frequency is also the
maximum flash frequency.
The flash frequency can be
changed using parameters.
The parameter "Switch-off de-
lay" is used for the pulse time
and the parameter "Switch-on
delay" for the pause time.
Continuous on
The output switches to conti-
nuously "On". All operations of
radio transmitters and the
Prog button are ignored.
Continuous off
The output switches to conti-
nuously "Off". All operations of
radio transmitters and the
Prog button are ignored.
Explanations
Disables manual commissio-
ning for all device channels. In
the "Off" setting, the device
cannot be reset to the factory
setting.
In addition to its other func-
tions, the device can be used
as a repeater. In the "On" set-
ting, the device repeats all the
received telegrams.
Explanations
5/10