Installation Preparation; Mounting Plate Installation - Craftmade TMPH52 Guia De Instalacion

3. Installation Preparation.

To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400 square
feet (37.2 square meters).
This fan can be mounted as a flushmount on a
regular (no-slope) ceiling only. Downrod
installations are not available for this fan.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.

4. Mounting Plate Installation.

Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch is
turned to the OFF position.
WARNING: Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING: When using an existing outlet box, be sure
the outlet box is securely attached to the building
structure and can support the full weight of the fan.
Ensure outlet box is clearly marked "Suitable for Fan
Support." If not, it must be replaced with an approved
outlet box. Failure to do so can result in serious injury.
CAUTION: Be sure outlet box is grounded properly
and that a ground wire (GREEN or bare) is present.
Install mounting plate to outlet box using original
screws, spring washers and flat washers provided
with new or original outlet box.* Pull electrical
wiring from outlet box through center hole in the
mounting plate.
Locate screw on outer edge of mounting plate
closest to the j-hook and remove that screw. Then,
remove screw on outer edge of mounting plate
directly opposite the screw that was just removed.
Partially loosen the other 2 screws.
*Note: It is very important that you use the proper
hardware when installing the mounting plate as this
will support the fan.
blade edge
30
inches
7 feet
(76cm)
(2.13m)
flushmount
installation
CANNOT be
installed on
angled or
vaulted ceilings
mounting plate
flat washers
spring washers
outlet box screws
page 4
12 ft. - 20 ft.
(3.66m - 6.1m)
downrod
installation