Working Principle; Before Using Your New Ceramic Hob; Technical Specification; Operation Of Product - EAS ELECTRIC EMCH200-4F Manual De Instrucciones

2.4 Working Principle

This ceramic cooker hob directly employs resistance wire heating, and adjust the output power by the
power regulation with the touch controls.

2.5 Before using your New Ceramic Hob

 Read this guide, taking special note of the 'Safety Warnings' section.
 Remove any protective film that may still be on your ceramic hob.

2.6 Technical Specification

Cooking Hob
Cooking Zones
Supply Voltage
Installed Electric Power
Product Size D×W×H(mm)
Building-in Dimensions A×B (mm)
Weight and Dimensions are approximate. Because we continually strive to improve our products we may
change specifications and designs without prior notice.

3. Operation of Product

3.1 Touch Controls

 The controls respond to touch, so you don't need to apply any pressure.
 Use the ball of your finger, not its tip.
 You will hear a beep each time a touch is registered.
 Make sure the controls are always clean, dry, and that there is no object (e.g. a utensil or a cloth)
covering them. Even a thin film of water may make the controls difficult to operate.
EMCH200-4F
4 Zones
220-240V~ 50Hz or 60Hz
6000-7000W
590X520X55
560X490
8 V.2