Bosch GWS 14-125 Inox Professional Manual Original página 28

OBJ_BUCH-611-003.book Page 29 Monday, April 21, 2008 11:28 AM
Cup Brush/Disc Brush
For operations with the cup brush/wheel
brush, always mount the hand guard 15.
See graphics page for the mounting sequence.
The cup brush/disc brush must be able to be
screwed onto the grinder spindle until it rests
firmly against the grinder spindle flange at the
end of the grinder spindle threads. Tighten the
cup brush/disc brush with an open-end span-
ner.
Quick-clamping Nut
For convenient changing of grinding tools without
the use of additional tools, you can use the quick-
clamping nut 11 instead of the clamping nut 10.
The quick-clamping nut 11 may be used only
for grinding or cutting discs.
Use only a flawless, undamaged quick-clamp-
ing nut 11.
When screwing on, pay attention that the side
of the quick-clamping nut 11 with printing
does not face the grinding disc; the arrow must
point to the index mark 22.
Lock the grinder spin-
dle with the spindle
22
lock button 2. To tight-
en the quick-clamping
nut, firmly turn the
grinding disc in clock-
wise direction.
A properly attached,
undamaged quick-
clamping nut can be
loosened by hand
when turning the
knurled ring in anti-
clockwise direction.
Never loosen a tight
quick-clamping nut
with pliers. Always
use the two-pin span-
ner. Insert the two-pin spanner as shown in
the illustration.
Bosch Power Tools
Approved Grinding Tools
All grinding tools mentioned in these operating
instructions can be used.
The permissible speed [rpm] or the circumfer-
ential speed [m/s] of the grinding tools used
must at least match the values given in the table.
Therefore, observe the permissible rotation-
al/circumferential speed on the label of the
grinding tool.
max.
[mm] [mm]
D b
d
115 6 22.2
125 6 22.2
D
b
–
115
D
–
125
d
75 30 M 14
b
D
Rotating the Machine Head
Before any work on the machine itself, pull
the mains plug.
erations using the cutting guide with dust ex-
traction protection guard 20/cut off stand or for
left-handed persons.
1 609 929 R00 | (21.4.08)
English | 29
d [rpm] [m/s]
7500 55
7500 55
–
7500 55
–
7500 55
7500 45
The machine head
can be rotated with
respect to the ma-
chine housing in
90° steps. In this
manner, the On/Off
switch can be
brought into a more
convenient posi-
tion for special
working situations,
e.g., for cutting op-