Error Messages And Error Clearance - Weller WX 1 Manual De Uso

Error messages and error clearance

Message/symptom
Display: „- - -
No display function (display
OFF)
OFF
Channel cannot be switched on
WXD 2:
No vacuum at desoldering tool
WXD 2:
Insufficient vacuum at desolde-
ring tool
WXA 2:
Hot air tool has no air
Hintere RS 232:
Does not function with Zero
Smog/ WHP/PC/ WFV 60A
Warranty
Claims by the buyer for physical defects are time-barred after a period of one year from delivery to the
buyer. This does not apply to claims by the buyer for indemnification in accordance with §§ 478, 479
BGB (German Federal Law Gazette).
We shall only be liable for claims arising from a warranty furnished by us if the quality or durability war-
ranty has been furnished by use in writing and using the term „Warranty".
The warranty shall be void if damage is due to improper use and if the device has been tampered with by
unauthorised persons.
Subject to technical alterations and amendments.
For more information please visit www.weller-tools.com.
Possible cause
Tool has not been detected
„
Tool defective
„
No mains supply voltage
„
Overload cut-out
„
Channel switched off
„
Vacuum not connected
„
Desoldering nozzle clogged
„
Compressed air not or
„
incorrectly connected
Filter cartridge on desoldering
„
tool full
Main filter on soldering station
„
full
Air hose not connected
„
Compressed air not or
„
incorrectly connected
Robot output set to Stop/Go
„
Remedial measures
Check connection of tool to
„
device
Check connected tool
„
Turn on mains power switch
„
Check mains supply voltage
„
Check device fuse
„
Only one soldering iron can be
„
operated.
Connect vacuum hose to
„
vacuum connection
Service desoldering nozzle
„
using cleaning tool
Connect compressed air to
„
compressed air connection or
check
Change filter cartridge on
„
desoldering tool full
Change the main filter element
„
on the soldering station
Connect compressed air to
„
compressed air hose or check
Connect air hose of tool to
„
WXA 2 or check
Deactivate Stop & Go function.
Or use front RS 232 port.
39