Connections - Yamaha CDX-397MK2 Manual De Instrucciones

Before making any connection, switch OFF the power to
the unit and the amplifier or other component.
Connections should be made to the correct input
terminals of the amplifier or another component.
1
Audio pin cable
(included)
To connect this unit to your amplifier, choose one of the ways listed below.
Caution Do not plug in this unit to a wall outlet until all connections are complete.
When the LINE OUT (analog) terminals of
this unit are used (
Connect these terminals to the "CD" (or "AUX") terminals of
the amplifier. For details concerning these connections,
refer to the operation instructions of the amplifier being
used.
* Be sure that the left ("L") and right ("R") of these terminals are
connected to the corresponding (left and right) terminals of the
amplifier or another component.
The level of signals output from any of these terminals
into an amplifier can be adjusted by the
OUTPUT LEVEL +/– buttons.
When using the DIGITAL OUT (OPTICAL) terminal, set
the level of signals output into an amplifier to max. by
using the OUTPUT LEVEL +/– buttons.
To connect this unit to the AC outlet
After you made all connections, connect the power cable of this unit to the AC outlet.
4
En

CONNECTIONS

LINE OUT DIGITAL
OUT
OPTICAL
L
R
2
Optical cable
(not included)
CD
1
)
If the placement of this unit causes noise to another
equipment, such as a tuner, separate them from each
other.
OPTICAL
DIGITAL IN
When the DIGITAL OUT (OPTICAL) terminal
of this unit is used (
Make the connection from this terminal to the optical
input terminal of an amplifier by using a commercially
available optical cable.
* Use a reliable optical cable.
This terminal can also be connected to the optical input
terminal of an MD recorder etc. to record CD onto MD
directly.
Europe and U.K models
MAINS
To AC outlet
Amplifier
2
)