Wiring - Craftmade Stockman STK52 Guia De Instalacion

6. Wiring.

WARNING: Turn off circuit breakers to current fixture from
breaker panel and be sure switch is turned to the OFF
position.
CAUTION: Be sure outlet box is properly grounded and that a
ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building wires
are different colors than those referred to in the diagram to
the right, please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to the
desired length and then stripped.
WARNING: If using this fan in a WET location, this fan must
be connected to a supply circuit that is protected by a
Ground Fault Circuit Interrupter (GFCI) to reduce the risk of
personal injury, electrical shock or death.
When downrod is secured in place on the hanging bracket,
WIRE THE RECEIVER with wire connectors provided as
shown in diagram at right.
Tip: While you are wiring, keep in mind that wires must not
obstruct receiver from sliding into hanging bracket.
* Wrap each wire connector separately with electrical tape
as an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket
and carefully push taped wire connectors into outlet box.
Allow antenna from remote control receiver to hang
outside of hanging bracket.
[PLEASE NOTE: Wall and/or handheld remote control must
be used for fan to operate. If you do not wish to use the wall
control, please proceed to Section 7 to continue with fan
installation.]
To install wall control, remove existing wall switch. Wire one
of the wall controls with wire connectors provided as shown
in diagram at right.
*Wrap each wire connector separately with electrical tape as
an extra safety measure. Gently push wires and taped wire
connectors into outlet box.
Install one battery (included) in wall control.
IMPORTANT: Wall control will not function unless battery is
installed.
Since this fan comes with an LED light kit, the dimmer switch
(labeled DIM and ON) has been pre-set to the "ON" position
(DIM). If you do not wish to have dimming capability, please
move the switch to the "OFF" position (ON).
Select a faceplate (almond or white) and press firmly onto
front of wall control. Attach wall control to outlet box and
secure with screws from original wall switch. Attach wall plate
(included) to wall control using 2 screws provided with the
wall control.
white supply wire
black supply wire
blue
white
black
from fan
from receiver
black
white
blue
(wiring for receiver)
outlet box
green/ green/ green/
bare bare bare
ground ground ground
black
black
(AC IN from
breaker box)
(wiring for wall control)
page 6
ground
(green or bare)
ground (green
from ceiling
from receiver
black
AC IN L
white
AC IN N
receiver
antenna
wall
control
green
DIM ON
black (OUT to fan)
black
(TO POWER supply)
12V battery
or bare)
dimmer
switch
face-
plate
plate