English - Braun Satin Hair 1 Style&Go HD 130 Manual Del Usuario

English

Please read these use instructions
carefully before use and keep them for
future reference.
Important
• Before first use, check whether
the position of the voltage
selector (2) is set in line with
your local supply voltage. You
can select 230 V or 120 V.
• This appliance must never
be used near water (e.g.
a filled wash basin, bathtub
or shower). Do not allow the
appliance to become wet.
• When using the hairdryer in a
bathroom, always unplug it
after use. Even a switched-off
hairdryer presents a hazard if
not unplugged.
• For additional protection, it is
advisable to install a residual
current device (RCD) with a
rated residual operating cur-
rent not exceeding 30 mA in
the electrical circuit of your
bathroom. Ask your installer
for advice.
• Care should be taken not to
block the inlet and outlet grill
when the hairdryer is switched
on. If either grill becomes
blocked, the hairdryer will
automatically cut out. After
cooling for a few minutes,
it will switch back on auto-
matically.
6
• Do not wrap the mains cord
around the appliance. Regu-
larly check the mains cord for
wear or damage. If the cord is
damaged, it must be replaced
by an authorized Braun Service
Centre in order to avoid a
hazard.
• This appliance can be used by
children aged from 8 years
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have been given super-
vision or instruction concerning
the safe use of the appliance
and understand the hazards
involved. Children shall not
play with the appliance.
Cleaning and user mainte-
nance shall not be made by
children unless they are older
than 8 years and supervised.
Foldable handle
Before first use, fold out the handle into
use position so that it snaps into place.
Air flow and temperature switch (1)
O = off
I = gentle drying
II = fast drying
Voltage selector (2)
When the hairdryer is unplugged, you
may change the voltage setting (120 V or
230 V) by means of the voltage selector.