MAT Industries PWFC132600 Manual De Operación página 8

OPERATING INSTRUCTIONS (CONT.)
• SAVE ALL INSTRUCTIONS
PRESSURE WASHER OPERATING FEATURES PRESSURE
ADJUSTMENTS
The pressure setting is preset at the factory to achieve optimum pressure and cleaning. If you need a lower pressure, it can be accomplished by
these methods.
1. Back away from the surface to be cleaned. The further away you are, the less the pressure will be on the surface to be cleaned.
2. Change to the 40° nozzle – this nozzle delivers a less powerful stream of water and a wider spray pattern.
C A U T I O N
DO NOT attempt to increase pump pressure. A higher pressure setting than the factory set pressure may damage pump.
TO USE SPRAY WAND
The nozzles for the spray wand are stored on the top storage panel.
See chart to choose the correct nozzle for the job to be performed.
CHANGING NOZZLES ON SPRAY WAND
D A N G E R
RISK OF FLUID INJECTION.
direct discharge stream toward persons, unprotected skin, eyes or any
pets or animals. Serious injury will occur.
W A R N I N G
RISK OF FLUID INJECTION.
attempt to change nozzles while pressure washer is running. Turn
engine off before changing nozzles.
1. Pull back the quick connect collar on the spray wand and hold it in
place.
2. Insert the desired quick connect nozzle and hold in place.
3. Slide the quick connect collar forward until it locks into place.
4. Check that the quick connect nozzle is securely locked into the
spray wand.
Spray
Pattern
Uses
Surfaces*
C A U T I O N
*
to surfaces such as wood, glass, automotive paint, auto striping and trim, and delicate objects such as
fl owers and shrubs. Before spraying, check the item to be cleaned to assure yourself that it is strong
enough to resist damage from the force of the spray.
Copyright © 2011 MAT Industries, LLC
Do NOT
Do NOT
0° 15°
Powerful Intense clean-
pinpoint for ing of small
very intensive areas
cleaning
Metal or con- Metal, concrete,
crete or wood
DO NOT use
on wood
The high pressure spray from your pressure washer is capable of causing damage
25° 40°
Intense clean- Intense cleaning
ing of medium of larger areas
areas
Metal, concrete, Metal, concrete,
or wood or wood
8 - ENG
FIG. 6
Soap
Applies clean-
ing solutions
Metal, concrete,
or vinyl
200-2835