Beurer HT 62 Instrucciones De Uso página 23

4. Insert the mains plug into a suitable socket. "OFF" appears on the LED operating display [3]. Press the ON/OFF button [6]
for 2 seconds to switch on the curling tongs. The current set temperature appears on the LED operating display [3]. Set
your desired temperature setting using the (+) button [4] or (-) button [5]. The current set temperature setting is shown on
the LED operating display [3]. The heat-up phase is indicated by the temperature display flashing. When the temperature
display is continuously lit, the curling tongs have reached the set temperature setting and can be used. The temperature
can be permanently set by pressing the ON/OFF button [6] twice. The LOC symbol appears in the display.
5. Put on the heat-resistant glove.
6. Separate your hair into individual sections with a width of approx.
2 centimetres. Wind the hair sections around the curling tongs
as shown. Hold the section of hair in place at the tip [1] using
your hand with the heat-resistant glove. Never touch the conical
heating rod of the curling tongs [2] unless wearing the heat-re-
sistant glove.
7. Leave the curling tongs in your hair for 8 to 10 seconds in order
to achieve the desired curling effect.
Note
After 25 minutes of operation, the LED operating display [3] starts
to flash. This is to show you that the curling tongs will automatically
switch off in 5 minutes. The curling tongs switch off automatically
after 30 minutes of operation. Once switched off, the curling tongs
are no longer heated and the LED operating display [3] goes out.
Press the On/Off button [6] twice to switch on the curling tongs
again.
23