Assembling The Xl21 Handle Tube; Operating The Xl21; Xl21 Storage; Operating Recommendations - Oreck XL21 Serie Guia Del Usuario

Assembling the XL21 Handle Tube

Align slot in handle tube with tab in connector. Insert the handle tube into connector.
1
Tighten collar at base of handle tube onto the connector until it locks, "snaps".
Snap cord assembly into the cord clip located on the left side of the collar.
2
Leave excess cord at the power head to allow movement.

Operating the XL21

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner
without a paper filter dust bag. Plug the power cord into an electrical outlet and press the
On Low ( l l ) - On High ( l l l l ) - OFF ( O O ) switch on handle assembly when ready to operate.
Up-Position Lock -
Place foot on power head and lean handle back gently to
3
release lock for vacuum use. Return handle to the full upright position to engage
lock. Note: Do not operate the unit while in the upright and locked position. Do
not let the unit run while in any one stationary position for any period of time. Keep
the unit moving while in operation.
Carry Handle -
Raise the carry handle located onback of the unit for easy lifting,
4
carrying, and stair vacuuming. Lower the handle during use to eliminate obstruction.
Duster Loop -
For convenient use of dusters, a loop has been sewn onto the outer
5
bag. This will allow easy removal and storage of the duster.
Easy Power Cord Storage -
6
around carry handle and Helping Hand
7 To release cord, twist cord dump located on Helping Hand
Slide cord off handle.

XL21 Storage

Both the Helping Hand ® handle and carry handle can be used for convenient, space
saving storage of cleaner. Hang cleaner by carry handle on a sturdy fastener or Helping
Hand handle on a closet rod.

Operating Recommendations

This new ORECK XL21 High-Speed Upright is one of the finest, fastest, and strongest
units in its class. You'll love the way it cleans, gets under things, and it's SO lightweight
and easy to use.
The following are a few simple suggestions regarding its operation:
1. When inserting a new disposable paper filter dust bag -FIRST PUFF OUT
and OPEN THE BAG.
2. When the disposable paper filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or makes an unusual noise,
STOP OPERATION and service.
4. Although your upright will pick up pins, paper clips, and other small objects, it is
recommended that these be removed from the floor before you vacuum. Failure to
do so may result in permanent damage to the motor suction fan and its housing.
5. WARNING: Do not use your vacuum cleaner on damp or wet surfaces. This will
cause damage to the vacuum cleaner and is dangerous to the user. Damage caused
by use on wet or damp surfaces is not covered under warranty.
6. REPLACE THE BELT EVERY 6 MONTHS, SCENT CARTRIDGE EVERY
MONTH, AND MOTOR FILTER EVERY 2 MONTHS.
7. Change the disposable paper filter dust bag at least once a month - even if it is not
full!The collected dust in the dust bag can cause odor, attract moisture, and can
affect the efficiency of the cleaner.
8. DO NOT run the vacuum cleaner over the cord. The revolving brush could damage
the cord.
E N G
Raise carrying handle and wrap power cord
® handle.
®
handle 1/2 turn.
L I S H
3
5
4
1 2
4
6
7