Fitting The Carrying Ring - Stihl FS 56 Serie Manual De Instrucciones

English
4
7
8
9
1
1
Place the clamp (7) in the loop
N
handle (4) and position them both
against the drive tube (8).
Position the clamp (8) against the
N
drive tube.
Place the barrier bar (6) in position
N
as shown.
Line up the holes.
N
Insert the screws (1) in the holes
N
and screw them into the barrier bar
as far as stop.
Go to "Adjusting and Securing the
N
Loop Handle".
Leave the barrier bar permanently
mounted to the loop handle.
20
Adjusting and Securing the Loop Handle
6
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 15 cm (5.9 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
A
4

Fitting the Carrying Ring

Polymer Version
1
For position of carrying ring see "Main
Parts".
Push the carrying ring (1) over the
N
drive tube.
Insert the M5 nut in the hex recess
N
in the carrying ring.
Fit the M5x14 screw.
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
Metal Version
The carrying ring comes standard with
the machine or is available as a special
accessory.
FS 56, FS 56 R, FS 56 C, FS 56 RC