Hunter 82001 Guia De Instalacion página 15

Existing Construction – accessible only from below
D11
D12
EXISTING FAN
F
Remove an existing fan and check to make sure the open- Move the housing into position above the ceiling
ing is large enough to accommodate the new motor hous-
ing (8"x 8 1/2").
D13
D14
.
Attach existing ducting to duct connector. Tape joints.
Route wires through strain relief
If ducting does not fit securely,
an adapter may need to be purchased.
D15
F
Install the housing flush with the sheetrock and secure by
tightening the pre-loaded screws into the joist.
41941-01 3/29/2006
15
05-HF-012-EngS_3.29.06.indd 15 3/29/06 3:19:35 PM