What Is Included; Dmx Linking; Signal Connection; Art-Net ™ Connection - Chauvet Professional MAVERICK FORCE S SPOT Guía De Referencia Rápida

Contact
Outside the U.S., U.K., Ireland, Benelux, France, Germany, or Mexico, contact a distributor to request support or return a
product. Refer to Contact Us

What is Included

• Maverick Force s Spot
• Seetronic Powerkon IP65 power cord
AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
Power Linking
It is possible to link up to 2 Maverick Force s Spot products at 100 V, 2 products at 120 V, 5 products at 208 V, 5 products
at 230 V, or 5 products at 240 V. Never exceed this number. Power-linking cords can be purchased separately.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Replacing the Fuse
1. Disconnect the product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

DMX Linking

The Maverick Force s Spot will work with a DMX controller using a 3- or 5-pin DMX serial connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Maverick Force s Spot uses a 3- or 5-pin DMX data connection for its DMX personalities: 22Ch and 29Ch. See the
User Manual for information about connecting and configuring the product for DMX operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer, as not all DMX controllers
have this capability. The Maverick Force s Spot supports RDM protocol that allows feedback to make changes to menu
map options. Download the User Manual from

Signal Connection

The Maverick Force s Spot can link to controller software using an Ethernet connection. If using other Art-Net™- or
sACN-compatible products with the Maverick Force s Spot, each product can be controlled individually on a single
network. See the User Manual for information about how to connect and configure the product for these signals.
Art-Net Connection
™
Art-Net™ is an Ethernet protocol that uses TCP/IP, which transfers a large amount of DMX512 data using an Amphenol
XLR Net RJ45 connection over a large network. An Art-Net™ protocol document is available from
www.chauvetprofessional.com. Chauvet Professional recommends using unicast Art-Net™ for best results.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, Streaming-ACN is an Ethernet protocol that uses the layering and formatting of Architecture
for Control Networks to transport DMX512 data over IP or any other ACN-compatible network.
Maverick Force s Spot QRG Rev. 1
QUICK REFERENCE GUIDE
at the end of this QRG for contact information.
Wire (U.S.)
Black
White
Green/Yellow
www.chauvetprofessional.com
• 2 Omega brackets with mounting hardware
• Quick Reference Guide
Wire (Europe)
Brown
Blue
Green/Yellow
for more details.
EN
Screw Color
Yellow/Brass
Silver
Green
2