USAGE AND MAINTENANCE INSTRUCTIONS
You have purchased a PANADERO product. Apart from correct maintenance, our
woodstoves require installation strictly in accordance with legislation. Our products
conform to the EN 13240:2001 and A2:2004 European norm, however it is very
important for you the consumer to know how to correctly use your woodstove following
the recommendations we set out. For this reason, before installing our product you must
read this manual carefully and follow the usage and maintenance instructions.
POSITION OF THE SMOKE PIPE
1) Place right-angled tube joint in smoke outlet at back of stove.
2) Place tube in bend, and do the same with the other tubes.
3) Join it to the rest of the chimney.
INSTALLATION
- All local regulations, including those referring to National and European standards need
to be complied with when installing the appliance.
- The installation of the smoke outlet must be as vertical as possible, avoiding the use of
joints, angles and deviations. If the installation is connected to a masonry chimney pipe we
recommend the tubes reach the exterior exit. If the smoke outlet is via tubing only, at least
three meters of vertical tubing are recommended.
- IMPORTANT: The installation and regular cleaning of this stove must be carried out by a
qualified professional. The ventilation opening must never be obstructed.
- IMPORTANT: The woodstove must be installed in a well ventilated place. It is advisable to
have at least one window in the same room as the stove which can be opened.
- The tube connections should be sealed with a refractory putty to prevent soot from falling
through the joints.
- Do not position the stove near combustible walls. The stove should be installed on a non-
combustible floor surface, if not a metal plate covering the bottom surface area of the stove
must be placed underneath it and extend further than 15 cm at the sides and 30 cm at the
front.
- Whilst the stove is in use remove any material nearby which could be damaged by the
heat: furniture, curtains, paper, clothes, etc. The minimum safety distance from adjacent
combustible materials is as shown on the last page of this manual.
- The ease of access for the cleaning of the product, smoke outlet and chimney must be
considered. If you intend to install your stove near an inflammable wall, we advise you to
leave a minimum distance to facilitate cleaning.
- This stove is not suitable for installation in any chimney system shared by other sources.
- The stove should be installed on flooring with adequate support. If your current floor
does not comply with this criterion, it should be adapted with appropriate measures (for
example, a weight distribution plate).
4