DeWalt DXV05P Manual De Instrucciones página 8

ENGLISH
BLOWING OPERATION
WARNING:
Always wear safety goggles complying with ANSI
Z87.1 (or in Canada CSA Z94.3) when using as
a blower.
WARNING:
To avoid injury to bystanders, keep them clear of
blowing debris.
CAUTION:
Wear a dust mask if blowing creates dust which
might be inhaled.
CAUTION:
To reduce the risk of hearing loss, wear ear
protectors when using the vac/blower for
extended hours or when using it in a noisy area.
The vac contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or
off patios and driveways. Follow the steps below
to use the vac as a blower.
1. Locate blowing port on the vac.
2. Insert one end of the 1-7/8 in. x 7 ft. hose into
the blowing port.
3. Turn vac "ON".
CARE AND MAINTENANCE
FILTER REPLACEMENT
WARNING:
To reduce the risk of injury from accidental starting,
unplug power cord before changing or cleaning
the lter. The lter should be cleaned often to maintain
peak vac performance.
WARNING:
Do not remove lter cage and oat. The oat
prevents water from entering the impeller and
damaging the motor. The cage prevents ngers
from touching the moving impeller.
IMPORTANT:
To avoid damage to the blower wheel and motor,
always reinstall the Clean Connect™ lter before
using the vac for dry pickups and wet pickups.
IMPORTANT:
After cleaning, check the lter for tears or small
holes. Do not use a lter with holes or tears
in it. Even a small hole can cause a lot of
dust to come out of the vac.
Replace it immediately.
NOTICE:
Before installing the lter on the vac, clean the
area of the lid so that the lter will seal against
the lid and stop small particles from bypassing
the lter bag. If the lter is clean and not
damaged, replace it on the lter cage.
If it cannot be reused, place a new lter over
the lter cage.
NOTICE:
Clean the lter in an open area. Cleaning should
be done outdoors and not in living quarters.
CLEANING:
To keep the wet/ dry vac looking its best, clean
the outside with a cloth dampened with warm
water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and
mild soap.
3. Wipe out with dry cloth.
STORAGE:
Before storing the vac, the dust tank should
be emptied and cleaned. The cord should be
wrapped and hung on the unit and the
accessories should be kept in mesh bag so
they can be readily available. The vac should be
stored indoors.
6