Installation Instructions - PNI GreenHouse WS55 Manual De Usuario

Proyector solar led
Ocultar thumbs Ver también para GreenHouse WS55:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 4
EN

INSTALLATION INSTRUCTIONS

Note: Check the correct operation of the product before installing it.
Connect the LED floodlight to the solar panel.
Caution: The floodlight is equipped with a twilight sensor.
- If the panel is exposed to daylight, the floodlight will not start automatically.
- At night, the floodlight starts automatically.
If you disconnect the floodlight from the solar panel, it will start automatically regardless of day / night.
Turn the floodlight on or off by pressing the ON / OFF button on the remote control. The light will blink
twice as confirmation of executing the ON / OFF commands.
Note: Position the remote control in front of the floodlight at a distance of approx. 1 - 15 m
Installing the solar panel:
A
B
30 - 45°
Installing the floodlight:
Fix the wall floodlight with the screws included
in the package
The angle of inclination of the floodlight can be
adjusted as required
Connect the male plug to the mother plug, then
tighten the anti-humidity nut
WARNINGS
Do not power the floodlight at a power source larger than 6V
Do not power the floodlight at a 230V AC power source
Make sure you have both the solar panel and the floodlight securely fastened in order to avoid accidents
in strong windy days
Periodically clean the surface of the solar panel to ensure a good sun exposure
The battery can only be fully charged by solar panel from sunlight under the following conditions:
AM1.5 - 1000W/m
AM1.5 = airmass coefficient at sea level
1000W/m
= the intensity of the sunlight radiation
2
25°C = charging temperature
In autumn, winter or on cloudy days, the intensity of the sunlight decreases greatly and also reduces the
charge on the battery, thus influencing the floodlight's working life.
C
Install the solar panel on the roof or on the wall. Attach the U-shaped
support to the solar panel with the screws included in the package.
Note: The panel should be oriented towards the sun (about 5 to 10
degrees southwest), with a 30 to 45° inclination from the horizontal
plane. The angle of inclination of the solar panel varies depending on
the geographic position, latitude and longitude of the location where it
is located.
A - Solar panel
B - U-shaped holder
C - Wall
Note: The solar panel must not be obstructed by buildings or trees to
provide continuous exposure to the sun. Also, do not install the solar
panel on the inside.
- 25°C for at least 8 hours.
2
2

Publicidad

Tabla de contenido
loading

Tabla de contenido