Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 9 – Connect Gas Line to Engine
Attach Gas Line to Control Valve:
Pull collar of Gas Line back.
Insert Gas Line over Control Valve.
Release collar and it should lock in place. (Tip – push Gas Line up from
bottom of Post to make a good seating before releasing the collar.)
Gently tug on line to test for proper connection. If Gas Line moves you
are not properly connected. Do not proceed until you have a proper
connection.
Fully tighten the (4) screws from Step 7.
Step 10 – Attach Top Dome to Emitter
Gently lay Heater on its side using one styrofoam insert to prop
up top half.
Align holes in Dome with threaded studs in Emitter brackets.
Secure Dome to Emitter using (3) Cap Nuts. Tighten using 13 mm
wrench.
Stand heater upright.
Step 11 – Secure Gas Line
Make sure angled side of Gas Clip pokes up through large hole in
Platform.
Tighten screw until Gas Line is held securely in place.
Stand Heater upright.
Owner's manual: model 235000 outdoor patio heater
NOTE:
The white ceramic cone in the top of the
engine is an important piece. DO NOT
REMOVE.
6/11/04
Section View
Gas Line
Clip
Bottom View
®
Gas Line
10