Pleasant Hearth OFG418TA Manual Del Usuario página 22

OPERATION INSTRUCTIONS
Note: Other cylinders may be acceptable for use with this appliance provided they have the same
profile and dimensions to be compatible with the appliance nesting hole and retention means.
Caution: Do not attempt to operate until you have read and understand all General Safety
Information in this manual and all assembly is complete and leak checks have been performed.
Before Turning Gas Supply ON:
1. Your fire pit was designed and approved for outdoor use only. Do NOT use it inside a building,
garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable
vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and
there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during
assembly or servicing is replaced and fastened prior to starting.
Before Lighting:
1. Fire pit should be thoroughly inspected before each use, and by a qualified service person at least
annually. If relighting a hot fire pit, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas
should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the
replacement hose assembly specified by manufacturer.
Lighting:
1. Turn the control knob to the "OFF" (
2. Fully open LP cylinder valve.
3. Push in gas control knob and turn counterclockwise to "IGNITER" ( ) (Figure B) to light the fire pit.
If needed, keep depressing and turning control knob counterclockwise until the fire pit lights
(You should hear a clicking sound).
4. After fire pit lights, release control knob. Push in and turn the control knob to the "HIGH" (
(Figure C), then release control knob. If you want a lower temperature, push in the control knob
and turn counterclockwise to the "LOW" (
Note: If burner fails to remain lit, all valves should be closed and a waiting period of at least
5 minutes should pass before attempting to light.
Figure a
Lighting operations should comply with Lighting Instructions section.
Improper lighting operations will cause serious injury and explosion.
) position (Figure A).
Figure a
Figure a
Figure A
Figure b
Figure a
WARNING
Figure b
).
Figure b
Figure B Figure C
Figure a Figure c Figure b
Figure b Figure c
22
Figure c
Figure c
in.
in.
in.
Normal Normal
Figure c
in.
in.
in.
in.
)
Normal
in.
in.
Figure a
Normal
i
in.
in.
i
i
in.
Abnormal Normal