Application Areas - Beurer FC 100 Instrucciones De Uso

7. Start the treatment at the lowest intensity level initially. Place the hand-held device
on your face and move it over the skin. Make sure that you do not move the
hand-held device over one part of the face more than once. Further details on
treatment can be found in Section "6.3 Application areas".
If the lowest intensity level is not strong enough for you, you can change this by
pressing the -/+ buttons.
Note
The pressure you apply when using the device should be comfortable and not painful. Some slight reddening should
be expected after use.
8. When you have finished using the device, press the ON/OFF button to switch it off and unplug the mains adapter
from the socket.
9. Change the single-use filter after every use. To do this, disconnect the hand-held
device from the tube. Use tweezers to remove the single-use filter.

6.3 Application areas

Note
Ensure that the part of your face you are treating is taut when you move the hand-held device over the skin.
You can do this by pulling the skin taut to the side or downwards with your free hand.
Forehead:
Move the hand-held device slowly and evenly outwards from the centre of the forehead.
Make sure that you do not treat any part of your skin more than once.
Temples:
Move the hand-held device outwards towards your hairline. Repeat this to the left and right
of the nose. Ensure that the device is at least 1 cm away from your eyes.
Nose:
Move the hand-held device downwards from the centre at the top of the bridge of your nose.
Repeat this to the left and right of the nose.
Cheeks:
Move the hand-held device outwards across your cheeks.
Around the mouth:
Move the hand-held device along your upper lip from the centre to the left and right. Move
the hand-held device upwards from your bottom lip to the left and right. Make sure that you
do not touch your lips.
15