Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATIONS AND FEATURES
Using the Remote Control
Power
This will turn the unit ON
and OFF. When the unit is
turned back ON, the system
will recall the last heat
setting used. Store flame
and Heating setting.
Adjust Brightness
This allows you to raise or lower
the level of flame brightness.
Note: when the unit is turned
off that the LOGS completely
die out for 3 seconds.
Timer
This allows you to set the
fireplace to automatically shut
OFF after the amount of time
displayed on the screen, the
timer can be set from 10
minutes to 9 hours, the display
shows 10, 20, 30, 40, 50, 1H, 2H,
3H, 4H, 5H, 6H, 7H, 8H, 9H. Do
not operate fireplace while
unattended.
Using the Control Panel
Timer/Dynamic Embers
This will allow you to set the
automatic shutoff on the
fireplace. Dynamic Embers
will work on the unit hold 5
seconds when beeps press
again. To stop embers press
timer button then hold for 5
seconds.
EF19-23
MODEL#:
Adjust Temperature
This allows programming
of the thermostat. The
fireplace can be used
without the heater if
desired. Simply cycle
through the function until
no temperature is
displayed. Press and hold
the button for five seconds
to switch temperature
readout from
(Fahrenheit) and
℉
℃
(Celsius) and back.
Adjust Temperature
This allows programming of the
thermostat. The fireplace can
be used without the heater if
desired. Simply cycle through
the function until no
temperature is displayed. Press
and hold the down arrow for
five seconds to switch
temperature readout from
(Fahrenheit) and
℉
and back. Must be in Heat
mode.
This function will make the
embers of the fire
automatically glow dimmer and
brighter creating a more
realistic fire effect.
Adjust Brightness
This function will cycle
through the five
different levels of flame
brightness.
(Celsius)
℃
Dynamic Embers
Power
This will turn the unit ON
and OFF. When the unit is
turned back ON, the system
will load default factory
settings.
Page 8 of 12
Publicidad
Capítulos
Tabla de contenido
