Connecting The Water Line - LG SRFVC2406 Serie Manual Del Usaurio

us_main.book.book Page 18 Wednesday, January 29, 2020 2:11 PM
18 INSTALLATION
1
Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator
door onto the middle hinge.
2
Fit the hinge over the hinge lever latch
a
and slot it into place. Rotate the lever
clockwise and fasten the hinge.
3
Connect all the wire harnesses and the
ground wire.
4
Push the water supply lines into the hole on
the top case and pull them through the
backplate.
5
Hold the water supply connection and gently
push in the collet
d
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
b
c
to connect the water
NOTE
• Disassembling/Assembling the Water Lines
Collet Tube Insert line
e f g
• Gently press the collet and insert the tube until
only one line shows on the tube.
Assembling the Hinge Cover
Position the hinge cover in its place. Insert and
tighten the cover screws.

Connecting the Water Line

Before Beginning
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
If necessary, call a qualified plumber to correct
water hammer before installing the water supply
line to the refrigerator. Water banging in the
pipes, or water hammer in residential plumbing
can cause damage to refrigerator parts and lead to
water leakage or flooding.
• Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
Clip
h