General Safety Rules - Roberts 10-286G Manual Del Usuario

GENERAL SAFETY RULES

instructions listed below may result in electric shock, fire, serious personal
injury, or damage to carpet.
SAVE THESE INSTRUCTIONS
Work Area
Do not expose tools to rain. Do not use tools in a damp or wet location.
Keep your work area clean and well lit. Do not use tools in the presence of
flammable liquids or gases.
Personal Safety
Stay alert, watch what you are doing and use common sense when operating
electrical tools. Do not use tool while tired or under the influence of drugs,
alcohol or medication. Dress properly. Do not wear loose clothing or jewelry.
Keep long hair, clothing and jewelry away from moving parts. Avoid touching
the heat shield or base when using the iron. Wear gloves when seaming.
TOOL USE AND CARE
Seaming Tape. It is not intended for any other use.
The handle of the iron is molded from a very durable fiberglass filled nylon
material. The base is a non-stick coated die-cast aluminum and the iron is
equipped with an insulated stainless steel heat shield.
It runs on 120-volt standard U.S. electrical current. Do not change cords,
plugs or electrical components. Take the iron to an authorized repair shop for
repairs. Do not pull the plug from the socket with the cord. Grasp the plug
and pull from the socket. This iron is intended for indoor use only.
Extension Cords
Only use extension cords that are intended for indoor use. These extension
cords are identified by the statement: "Acceptable for use with indoor
appliances; store indoors while not in use". Only use extension cords having
an electrical rating that is higher than the rating of the product. Do not use
damaged extension cords. Examine extension cord before using and replace
if damaged. Do not abuse extension cords and do not yank on any cord to
disconnect. Keep cord away from heat and sharp edges. Always disconnect
the extension cord from the receptacle before disconnecting the product from
the extension cord.
Read and understand all instructions. Failure to follow the
This iron is used for melting adhesive on Heat Bond Carpet
– 2 –