Oven Racks - GE PSS93 El Manual Del Propietario

Oven Racks

Recommended rack positions for various types of
foods are provided in the Cooking Guide. Adjusting
rack position is one way to impact cooking results. For
example, if you would prefer darker tops on cakes,
muffins, or cookies, try moving food one rack position
higher. If you find foods are too brown on top try moving
them down next time.
When baking with multiple pans and on multiple racks,
ensure there is at least 1½" between pans to allow
sufficient space for air to flow.
To avoid possible burns, place the racks in the desired
position before you turn the oven on.
The number of rack positions may vary by model.
Extension Racks
Always pull the rack out by its upper front rail to its fully
open position, when placing or removing cookware.
Extension racks cannot be used in the top rack position.
Fully Open Position
If extension racks are difficult to extend, lubricate the
racks with the graphite lubricant provided with your
oven. Remove the rack from the oven, remove debris in
the side tracks with a paper towel, shake the graphite
lubricant and place 4 small drops on the two bottom
tracks of the left and right sides. Open and close the
rack several times to distribute the lubricant.
To order additional graphite lubricant, read the
Accessories section of the manual.
49-2000723 Rev. 0
To Remove An Extension Rack:
1. Make sure the rack is pushed all the way into the oven
2. Slide the rack toward you to the bump (stop position)
3. Firmly grasp both sides of the rack frame and the
To Replace An Extension Rack:
1. Firmly grasp both sides of the rack frame and the
2. Place the curved end of the rack (stop-locks) onto
If extension racks are difficult to replace or remove, wipe
Rail
on the rack slides.
NOTE:
or a rust like color residue on the racks and cavity sides.
To clean this residue, use a soap and water or a vinegar
and water solution. Rinse with clean water and dry with
a soft cloth.
To Lubricate the Paddle:
Shake lubricant and apply to the moving parts of the
paddle mechanisms as shown.
so that side paddles on the rack disengage from the
oven support.
on the rack support.
sliding rack, tilt the front end up and pull it out.
Grasp here
sliding rack.
the oven supports, tilt up the front of the rack and
push it in as far as it will go.
15