Palmer PMC1 MONICON Manual De Usuario página 10

CONNECtION OF AN INtErFACE
UsB /
Firewire
if you have an interface with Xlr or 6.3 mm trs outputs, it also to use balanced connections. to do this,
use high-quality shielded patch or microphone cables.
note: MaKe Certain tHat yoUr Monitors are tUrneD oFF so tHat no loUD noises (PoPs)
oCCUr WHen tHe PlUgs are inserteD.
• Connect the left/right outputs of the interface to the inputs of the Monicon.
• Connect the output of the Monicon to your monitors.
• set the output volume of your computer to maximum or the master control of your software to 0dB.
• turn the volume control of the Monicon to full attenuation (all the way to the left).
• now turn on your monitors.
• Make certain that the mute function of the Monicon is deactivated and slowly turn up the volume control of
the Monicon.
note: iF tHe Control range is too great or tHe oUtPUt level is too loUD, tUrn DoWn tHe
volUMe oF yoUr Monitors. For an iDeal signal-to-noise ratio, tHe volUMe oF tHe CoMPUter
sHoUlD alWays Be set to MaXiMUM.
10
Computer
interface / sound Card
Xlr / f
Xlr / f