Descargar Imprimir esta página

Shark NV100 Manual Del Usuario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

Checking for Blockages
Blockages may cause your vacuum
to overheat and shut down. If
this occurs, clear the blockages,
then follow the instructions for
Resetting the Motor Thermostat
on page 11.
I MPORTANT: Never insert sharp
objects into any opening to clear
an obstruction. Damages caused
while clearing or attempting to
clear blockages are not covered
under your product's limited
warranty.
Unplug the vacuum
before checking for
blockages.
Reassemble all parts
securely before
operating vacuum.
Fig. 22
1 DUST CUP AIR DUCT:
3
S tand vacuum upright.
R emove Dust Cup Assembly and
empty Dust Cup if necessary.
C heck Air Duct behind Dust Cup
for clogs; clear before replacing
1
Dust Cup Assembly. (Fig. 21)
2 H OSE INTAKE OPENING:
H old the top of the hose access
door and pull firmly to remove.
Slide the knob to the center and
pull out the hose. (Fig. 22)
R emove any obstructions and
2
push the hose back in.
S lide the knob to the left and
snap the hose access door shut.
10
TOLL FREE: 1-800-798-7398
Fig. 21
Fig. 23
3 H OSE:
D isconnect the Stretch Hose by
gently pressing the tabs together
and pulling away from the hose
connector.
R emove hose from both the unit
and handle ends. (Fig. 23)
I nspect the length of the hose
and remove any obstuctions.
Maintenance
Get even more cleaning from your Shark
Navigator
Resetting the Motor Thermostat
Your Shark
®
Navigator
is
equipped with a protective Motor
Thermostat. If the motor should
Bookmark the page and check back often
overheat, the thermostat shuts off
to take advantage of the latest products,
the power.
ADDITIONAL ACCESSORIES (AVAILABLE FOR PURCHASE):
MULTI-TOOL
C onvenient crevice tool and dusting brush in one.
PET/UPHOLSTERY TOOL
R emoves hair from upholstery and stairs.
CREVICE TOOL
R each deep into narrow spaces and clean between cushions,
under radiators and baseboards and in hard to reach crevices and
TO RESET THE MOTOR
corners.
THERMOSTAT:
NOTE: Some accessories may be included with your
Press the Power Button ( )to turn
purchase.
the unit "Off".
Unplug the vacuum.
Check for clogged hose or filter;
To order Additional Parts &
unclog hose and replace filter.
Accessories go to
Refer to Checking for Blockages
www.sharkclean.com.
on page 10.
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Press the Power Switch ( ) to start
the vacuum.
NOTE: If vacuum still does not start,
contact Customer Service at:
1-800-798-7398.
by checking out our cleaning
accessories assortment at
www.sharkclean.com.
promotions and prices!
PART
PART NO.
Stretch Hose
Multi-Tool
Foam & Felt Filter
Extension Wand
24" Crevice Tool
11" Crevice Tool
Pet/Upholstery Tool
www.sharkclean.com
English
®
126FFJ
127FFJ
XFL100
1116-FC
122FFJ
129FFJ
128FFJ
11

Publicidad

loading