Cleaning And Maintenance; Technical Specifications - HQ-Power VDL500SM Manual Del Usuario

• It may happen that the standby lamp on the remote control is off and the smoke emission stops, even
while you are holding the button. In this case the device is warming up again and will be ready to
resume operation in a few minutes' time. This process guarantees an appropriate vaporisation
temperature and the best smoke emission possible.

7. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. Mechanically moving parts must not show any signs of wear and tear.
3. The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. There are no user-serviceable parts, apart from the fuse (see "5. Installation").
7. Contact your dealer for spare parts if necessary.
8. Clean the heating element after every 30 hours of use with a special cleaning liquid available from
your dealer. Fill the tank with the cleaning liquid and let the machine run for a while. When the device
is cleaned, remove the remaining cleaning liquid and rinse the tank thoroughly with distilled water.
Never use regular water for cleaning or rinsing!

8. Technical Specifications

power supply
power consumption
fuse
smoke output
warm-up time
tank capacity
dimensions
weight
max. ambient temperature
max. housing temperature
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.hqpower.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
23.12.2010
VDL500SM
max. 230VAC/50Hz
max. 500W
F 5A, 250VAC (5 x 20mm) (order code FF5N)
55m³/min
approx. 5-8 minutes
0.95 litres
280 x 170 x 140mm
2kg
45°C
130°C
5
Rev. 01
©Velleman nv