Assembly - Bosch BDU480 CX Instrucciones De Servicio

Inserting and removing the battery
For inserting and removing the eBike battery in/from
the eBike, please read and observe the battery oper-
ating instructions.
Check speed sensor
A
(3)
(1) Speed sensor (standard)
(2) Spoke magnet
(3) Speed sensor (slim)
(4) Magnet
A) Different sensor shape and installation position possible
Speed Sensor (standard)
The speed sensor (1) and its spoke magnet (2) must
be fitted such that the spoke magnet moves past the
speed sensor at a distance of at least 5 mm and at
most 17 mm with each rotation of the wheel.
Note: If the distance between the speed sensor (1)
and the spoke magnet (2) is too small or too large, or
if the speed sensor (1) is not properly connected, the
speedometer display will fail and the eBike drive unit
will operate in emergency mode.
Should this occur, loosen the screw of the spoke mag-
net (2) and fasten the spoke magnet to the spoke
such that it runs past the marking on the speed sen-
sor at the correct clearance. If the speed is still not
Bosch eBike Systems
(1)
(4)
(2)
A)

Assembly

being indicated on the speedometer display after do-
ing this, please contact an authorized bicycle dealer.
Speed Sensor (slim)
The speed sensor (slim) (3) and its spoke magnet (4)
must be fitted ex works such that the spoke magnet
moves past the speed sensor at a distance of at least
2 mm and at most 8 mm with each rotation of the
wheel.
The correct distance between the magnet and sensor
must be maintained (see figure A) if design changes
are made.
Notes: Ensure that you do not damage the sensor or
sensor bracket when fitting or removing the rear
wheel.
English – 7
0 275 U07 XD4 | (09.04.2020)