Replacing The Decorative Door Panel; Customer Service - Dometic RH 131 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 40
11. Replacing the decorative
door panel,
Remove the two screws (1) from the upper hinge of
the door.
Pull the door together with the hinge away from the
housing and up off the lower hinge bolt (2-3).
Remove screws (4) and pull off the frame edge (5).
Slide the decorative panel (6) out of the door frame
and insert the new panel (7), so that the upper edge
of the panel runs exactly parallel to the upper edge of
the frame. A new panel can be inserted more easily
into the upper edge of the frame when the two corners
are cut off by approx. 5 x 5mm (8). Put the frame edge
(5) back in place and secure with screws.
Place the door on the lower hinge (9), slot the upper
hinge into the opening, press together with the door
against the housing and secure with the two screws
(11).

12. Customer service

Before you call a service engineer, carry out the
following simple tests:
Problem
The appliance does not
cool sufficiently
The appliance does not
cool at all
Figure 7.
(Fig. 8-10)
Possible cause
Thermostat control is set too low
Too much food to be cooled was put in
Door is not shut properly.
Refrigerator not level
Internal air circulation is restricted.
External air circulation is restricted.
Plug is not connected to the mains
socket properly.
There is no voltage in the mains socket
Figure 8.
Figure 9.
Figure10.
Solution
Set to a higher position
Put in less food to be be cooled
Check if the door is shut
Level refrigerator
Provide inside cool air circulation.
Provide outside air circulation.
Check if the connection is proper.
Check if there is voltage.
(eg. Connect a lamp to the socket)
GB
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rh 141Mf20-60

Tabla de contenido