Descargar Imprimir esta página

User Guide; Safety Instructions; Cleaning And Maintenance - Toolland FT100-TL Manual Del Usuario

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
FT100-TL
Soldering Torch

User Guide

Please read the manual thoroughly before bringing this
device into service. If the device was damaged in transit,
do not install or use it and contact your dealer.

Safety Instructions

This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children shall be supervised to ensure that
they do not play with the appliance.
Indoor use only. Keep this device away from
rain, moisture, splashing and dripping liquids.
Never put objects filled with liquids on top of
or close to the device.
Do not use near inflammable products or in
explosive atmospheres. Heat can cause fire to
inflammable products even when they are not
in sight. Only use in properly ventilated rooms.
Incorrect use may cause fire.
Do not touch the shafts, tips, or hot air gun as
this can cause serious burns. Keep the tips and
hot air away from the body, clothes, or other
flammable material. Do not aim the device at
the eyes. Use gloves and/or heat-resistant
tools to pick up the PCB assembly to prevent
burns. Always return the irons and gun to their
stands between uses; always let the device
cool down after use and before storage.
Place the device on a level, stable, and fire
resistant working surface.
Do not inhale solder fumes. The vapours that
are released during soldering are harmful.
Therefore, you shall only use the soldering
station in well-ventilated areas or under an
exhaust hood (solder fume extractor). Dispose
of fume filters and solder residue in
accordance with local regulations.
v 2 - 2/12/2014
Never use the device on live electronic circuits.
Make sure power to the work piece is cut and
capacitors are discharged.
Do not block the device nozzle. This may cause
heat reflection and may damage the heating
element.
Warning! Do not leave the device unattended
when switched on.
-
Use the blowtorch in a horizontal position.
-
Once the torch is lit, let it warm up for 30 seconds.
If the torch is not completely warmed up or moved
brusquely it may flare up. If this happens, keep the
torch in a vertical position for a few seconds.
-
If the piezoelectric device presents faults, check the
ignition electrode.
Use
Switching the device on
Torch with normal ignition
-
Turn the adjusting knob one counter clockwise.
-
Light the gas immediately at the burner, with a
match or lighter.
Adjustment
The flame is adjusted by turning the adjusting knob.
Turning the device off
Turn the adjusting knob clockwise until completely
closed.
Accessories
Make sure the torch valve is closed, turn the adjusting
knob clockwise. Unscrew the burner counter clockwise.
Mount the desired burner screwing down hand tight
only. Mount the desired accessory screwing down hand
tight only.

Cleaning and Maintenance

-
Let the device cool down before maintenance.
-
Do not carry out maintenance or repairs, other than
the following.
-
Use only original spare parts and accessories.
User Guide
p. 2 / 13

Publicidad

loading