Operation - Cameo PHANTOM F3 Manual De Usuario

6 CANISTER
Fluid canister with screw cap and intake hose. The sinter filter on the end of the intake hose ensures that contaminant particles do not get
into the system and that the hose end is always at the lowest point of the canister. Before filling the canister, disconnect the fog machine
from the power supply (remove the power plug). To prevent burns, let the fog machine cool down sufficiently. Unscrew the cap from the
canister and fill it with suitable fog fluid, making sure that no fog fluid can get into the device (take the canister out of the fog machine).
Insert the intake hose back into the canister and close it carefully with the cap. Never operate the fog machine without fog fluid.
FOG OUTPUT NOZZLE
7
The fog output nozzle is located on the front side of the fog machine. Caution, very hot! When setting up and assembling the fog machine,
follow the information under "CAUTION! IMPORTANT INFORMATION ON FOG MACHINES!" in the safety instructions.
HANDLE SCREWS
8
Handle screws for adjusting the mounting bracket.
9 VENTILATION SLOTS
Ventilation slits are located on the top side of the device. Ensure that the ventilation slits are not covered and that air can circulate freely.
SAFETY POINT
10
Safety point for securing the device on crossbeam installations.

OPERATION

NOTES
• Remove the protective film from the front of the fog machine before first use.
• After connecting to the mains, the evaporator will start to heat up (for approx. 4 minutes), during which time the HEATING LED will be lit
and the fog output cannot be started. When the heat-up phase is over, the READY LED lights up and the fog machine is ready for use.
• Do not operate the fog machine without fog fluid! Check the level at regular intervals and refill fog fluid if necessary (unplug the device
before filling).
In order to remove fluid residue in the vaporizer system of your fog machine and thus ensure a long service life, clean the vaporizer system
regularly (approx. every 60 operating hours). To do so, use the special Cameo cleaning fluid for fog machines and follow the instruction on
the bottle label.
6
6
10
9