Connecting Garden Hose to Pressure Washer (See fig 10)
•
Run water through the hose for a few seconds to flush any debris from the hose.
•
Inspect inlet screen and remove any debris.
•
Connect hose to water inlet and tighten by hand. There must be a minimum of 10 feet of unrestricted hose between
pressure washer and faucet or shut off valve.
•
Turn on water.
•
Purge the system's pump of air by releasing the safety and squeezing the trigger of the spray gun.
CAUTION!
Connect High Pressure Hose to Pump (See Fig 11)
•
Attach high pressure hose to the pump, pull back the quick-connect collar of pump.
•
Insert the hose nipple into the pump quick connector and then release the QC collar.
•
Once the high pressure hose is connected, pull on the hose to make sure the hose is firmly attached.
Do not run pump without connecting to the water supply and turning water on. Failure to
do so could damage the pressure washer. Failure to follow these instructions will void
product warranty.
ASSEMBLY
FIG 10
FIG 11
14