Weller WXP 200 Manual De Uso página 16

4-8
− Always pass on the WXP 200 soldering iron to third parties
together with these operating instructions.
− The manufacturer accepts no liability for improper use of the tool
or for unauthorised modifications.
2.1
General − Always place the WXP 200 soldering iron in the intended safety
information rest.
− Remove all inflammable articles from around the hot soldering
iron.
− Always wear suitable protective clothing when using the
WXP 200.
− Never leave a hot WXP 200 unattended.
− Do not work on electrically live parts.
− Antistatic plastics are provided with conductive fillers to prevent
the build-up of static charge. This also reduces the insulating
properties of the plastic.
Do not work on electrically live parts.
− Always wear eye protection when working with soldering and
desoldering applications.
− Read and follow the operating instructions for the Weller WX
supply unit.
Handling − Do not place or leave hot soldering/desoldering tips on the
soldering/ worktop or on plastic surfaces.
desoldering
− Wet the tinned soldering/desoldering tips with solder once they
tips
have heated up in order to remove oxide layers that form during
storage or contamination from the soldering/desoldering tips.
− Ensure the soldering/desoldering tips are well wetted during
intervals between soldering and desoldering and prior to storage
of the device.
− Do not use aggressive fluxing agents.
− Always make sure that the soldering/desoldering tips are
properly seated.
− Select the lowest possible working temperature.
− Select the largest possible soldering/desoldering tip shape for
the application (roughly as large as the soldering pad).
− Wet the soldering/desoldering tips well to ensure efficient heat
transfer between the soldering/desoldering tips and the soldering
spot.
− Switch off the system if you do not intend to use the
soldering/desoldering tool for prolonged periods.
− Wet the tips before placing the soldering/desoldering tool in the
safety rest.
− Apply the solder directly at the soldering point, not on the
soldering/desoldering tips.
− Do not apply excessive force to the soldering/desoldering tips.
− Always make sure that the soldering iron is placed properly in the
safety rest.
Please observe the following guidelines:
WXP 200